SNR Cutoff Recommendations
February 04, 2005
The performance of an RF site survey involves more than just ensuring that users are able to connect to an access point. Learn what signal-to-noise ratio (SNR) to use for defining effective range boundaries.
When performing a radio frequency (RF) site survey, it's important to define the range boundary of an access point based on signal-to-noise (SNR) ratio, which is the signal level (in dBm) minus the noise level (in dBm). For example, a signal level of -53dBm measured near an access point and typical noise level of -90dBm yields a SNR of 37dB, a healthy value for wireless LANs. Don't let the unit "dB" throw you -- it merely represents a difference in two logarithmic values, such as dBm.
SNR Variance Impacts Performance
The SNR of an access point signal, measured at the user device, decreases as range to the user increases because the applicable free space loss between the user and the access point reduces signal level. An increase in RF interference from microwave ovens and cordless phones, which increases the noise level, also decreases SNR.
SNR directly impacts the performance of a wireless LAN connection. A higher SNR value means that the signal strength is stronger in relation to the noise levels, which allows higher data rates and fewer retransmissions -- all of which offers better throughput. Of course the opposite is also true. A lower SNR requires wireless LAN devices to operate at lower data rates, which decreases throughput.
Real-World ValuesI recently ran user-oriented tests to determine the impacts of SNR values on the ability for a user to associate with an 802.11b/g access point and load a particular webpage. For various SNRs, here's what I found for the signal strength (found in the Windows radio status), association status, and performance when loading the http://wireless-nets.com/staff.htm webpage from a wireless laptop. To ensure accurate comparisons, I cleared the laptop's cache before reloading the page:
> 40dB SNR = Excellent signal (5 bars); always associated; lightening fast.
25dB to 40dB SNR = Very good signal (3 - 4 bars); always associated; very fast.
15dB to 25dB SNR = Low signal (2 bars); always associated; usually fast.
10dB - 15dB SNR = very low signal (1 bar); mostly associated; mostly slow.
5dB to 10dB SNR = no signal; not associated; no go.
These values seem consistent with testing I've done in the past, as well as
what some of the vendors publish.
Based on this testing, I recommend using around 20dB as the minimum SNR for defining the range boundary of each access point. That ensures a constant association with fairly good performance. Keep in mind that the corresponding level of performance only occurs at the boundary of each access point. Users associating with access points at closer range will have higher SNR and better performance.
When measuring SNRs, be sure to use the same radio card and antenna as the users will have if possible. A variance in antenna gain between the survey equipment and user device will likely result in users having different SNR (and performance) than what you measured during the survey. Changes made in the facility, such as the addition of walls and movement of large boxes, will affect SNR too. Thus, it's generally a good idea to recheck the SNR from time-to-time, even after the network is operational.
Jim Geier provides independent consulting services and training to companies developing and deploying wireless network solutions. He is the author of the books Wireless LANs (Sams) and Wireless Networks - First Step (Cisco Press).